In a study published in the Journal of Materials Science, researchers synthesized a polyaniline, dodecylbenzene sulphonic acid, and yttrium oxide composite electrode material that demonstrated a maximum specific capacitance of 594 F g−1 at a current density of 1 A g−1 for supercapacitor applications. The research evaluated synthesized electrodes of pristine polyaniline, dodecylbenzene sulphonic acid-doped polyaniline, and the ternary polyaniline-dodecylbenzene sulphonic acid-yttrium oxide mineral-based composite. Across electrochemical assessments, the composite material displayed an energy density of 30 Wh kg−1 at a power density of 348 W kg−1 alongside an operational cycling stability of 88.2 percent after 3000 charge-discharge cycles.
The investigation utilized an in situ polymerization method to prepare the three distinct experimental formulations, aiming to improve functional electrode materials for supercapacitor systems. Specifically, the team synthesized pristine polyaniline, dodecylbenzene sulphonic acid-modified polyaniline, and the mineral-based composite integrating yttrium oxide particles. Following the chemical synthesis stage, the researchers systematically subjected all prepared materials to structural, morphological, electrical, and dielectric characterization. Structural evaluations were conducted through X-ray diffraction, morphological features were inspected via scanning electron microscopy, and elemental verification was established using energy-dispersive X-ray analysis alongside Fourier transform infrared spectroscopy.
Morphological analysis using scanning electron microscopy confirmed the formation of a platelet structure within the polyaniline-dodecylbenzene sulphonic acid-yttrium oxide composite. According to the experimental findings, this observed platelet configuration is more promising for facilitating effective charge transport across the electrode structure.
Intermolecular interactions and chemical bonding within the composite material were examined through Fourier transform infrared spectroscopy. The spectroscopic data revealed strong chemical interactions between the polyaniline-dodecylbenzene sulphonic acid matrix and the embedded yttrium oxide particles. Dielectric spectroscopy conducted over a broad frequency range spanning from 20 Hz to 1 MHz further clarified the dielectric characteristics of the samples. These dielectric measurements revealed higher permittivity accompanied by frequency-dependent dispersion behavior, which the authors attributed directly to Maxwell-Wagner interfacial polarization occurring within the composite architecture.
Current-voltage measurements were carried out to evaluate the fundamental electrical transport characteristics of each prepared material. These direct current-voltage assessments demonstrated consistent ohmic behavior across all evaluated samples, including pristine polyaniline, dodecylbenzene sulphonic acid-doped polyaniline, and the ternary polyaniline-dodecylbenzene sulphonic acid-yttrium oxide mineral-based composite.
The electrical impedance measurements recorded a progressive decrease across the samples, dropping from approximately 5.4 ohms in pristine polyaniline to approximately 5.1 ohms in dodecylbenzene sulphonic acid-doped polyaniline, and reaching approximately 4.8 ohms in the polyaniline-dodecylbenzene sulphonic acid-yttrium oxide composite.
Comprehensive electrochemical performance evaluation was conducted using cyclic voltammograms, galvanostatic charge-discharge cycling, and electrochemical impedance spectroscopy. The resulting measurements established that the polyaniline-dodecylbenzene sulphonic acid-yttrium oxide electrodes achieved their highest performance at a specific capacitance of 594 F g−1 under a current density of 1 A g−1. When operating at an energy density of 30 Wh kg−1, the electrodes maintained a power density of 348 W kg−1 while retaining 88.2 percent of their initial performance after completing 3000 continuous charge-discharge cycles, underscoring the electrochemical viability of the synthesized composite.
Subject of Research: Polyaniline-yttrium oxide composite electrode materials for supercapacitors
Article Title: Polyaniline-dodecylbenzene sulphonic acid-Y2O3composites as an electrode material for supercapacitor applications
Article References: Irfan, M., Kanwal, N., Mofdal, M. E. E., Elisse, S., Knani, S., Almohammedi, A., Asif, M., & Fatima, M. (2026). Polyaniline-dodecylbenzene sulphonic acid-Y2O3composites as an electrode material for supercapacitor applications. Journal of Materials Science. https://doi.org/10.1007/s10853-026-14006-x
Image Credits: AI Generated
DOI: 10.1007/s10853-026-14006-x
Keywords: polyaniline, supercapacitors, electrode materials, yttrium oxide, dielectric spectroscopy, charge transport, cyclic voltammetry, energy density, Polyaniline-dodecylbenzene, sulphonic, acid-Y2O3composites, electrode
News Source: Denise Maddox. (November 9, 2026). Polyaniline and Yttrium Oxide Composites Advance Electrodes for Supercapacitor Applications. Scienmag.



